F O R T H E L O V E O F M U S I C ™MODEL 1002© (1984-MSRP $289.00)
QUALITY CONTROL: In-house construction of critical components like transformers and chassis pieces, as well as total assembly, allows LINEAR POWER™ to
4. +12V FOR TURN-ON: The red and white wire is not a main power source for the amplifier, but acts as an electrical switch to turn the amplifier on an
1002 Speaker Connector OPERATION IN BRIDGE MODE The Model 1002© amplifier must use an external pre-amp or crossover to be used as a bridgeable a
The large Red Wire (2) The (Red/White) wire but not at the large Black. Check by substitution or other method for proper operation of music source. B
NOISE TROUBLESHOOTING PROCEDURES 1. Start engine and let idle. 2. Turn system on. ADJUST INPUT GAIN ON AMP SO THAT IT IS TURNED DOWN AS FAR AS POSSIBL
insulation exposing the ground braid. Cut the braid and fold back Strip 2-3 of insulation off a scrap piece of wire and wrap around the ground braid n
Specifications 1002© Power output @ 4 ohms RMS @ 12.5 volts 50X2 Input sensitivity 200MV(max) – 5V(min) THD @ full output 20-20KHz +/- 1dB .15%
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED LINEAR POWER™ is a trademark of Linear Power, Inc. 9
Comments to this Manuals